We sell ceiling formwork based on the H20 girder system. It is most often used to make reinforced concrete elements such as ceilings and binders. It can also be used for the installation of prefabricated ceilings.

It is characterized by simplicity and a small number of elements forming the ceiling support: a tripod, a support, a head and a wooden H20 girder. A wide range of supports and girders makes the use of the girder system even on the most complex construction site. You receive a declaration of conformity and technical documentation for all the elements we sell




  • frame panels made of galvanized steel with the following dimensions: height – 270 cm, 300 cm, width – 30 cm, 45 cm, 50 cm, 55 cm, 60 cm, 65 cm, 70 cm, 75 cm, 90 cm,

  • connecting locks, tie rods with nuts, vertical supports, articulated corners and supports for working platforms.

The standard of each team is evidenced by the quality of each of its elements – this is also the assumption of DeltaBud. The precision of parts of our formwork system determines the highest quality of the entire mechanism.

The girders have a low weight, they are made entirely of impregnated, certified wood; they are not damaged or cracked, and their form is very stable. All supports are made of steel and hot-dip galvanized. Their height is adjustable and a special protection prevents accidental sliding of the inner tube. Our shuttering plywood deserves attention – it is a waterproof material that we impregnate with the utmost care. It is covered with a special substance which penetrates the structure of the wood during thermal and pressure treatment and protects it against external factors.

Assembly forks are an important element that our customers eagerly use. This component makes it much easier to assemble the entire structure, without worrying about safety. And when it comes to editing – every team will surely handle it. Only two people are needed to set up the formwork system. Using the instructions we have prepared, it can be done quickly and efficiently.

Importantly, it is possible to place the company’s logo in a visible place of the formwork (on the girder).